> I’m looking > for some good advise on how to redo this repair and also wondering if I can > use stronger materials (kevlor, polyethelene…?) for the patch and for a new > skid strip that might be tougher – not sure if I can marry these materials > to fiberglass. I would not bother with kevlar etc. They do not bond as well. They will not sand well. The strip is supposed to abrade. I would just use glass and epoxy and might then paint with gelcoat if I were concerned about UV degradation Redo when needed... *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Tue May 13 2003 - 10:49:41 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:06 PDT