>> Depends on what the bulkhead material is, but 3M 5200 is commonly used for this application. It comes in a fast(er) cure and a regular cure. Either kind should work here. Getting the old joint clean and abraded will be tricky, but the 5200 is a good gap filler, so it is OK to erode some bulkhead.>> Thanks Dave. *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:33:34 PDT