In a message dated 12/14/2003 7:43:57 PM Pacific Standard Time, kdruger_at_pacifier.com writes: I was unable to make my film tight while simultaneously leaving much gel coat underneath. The result is some replacement at the stern, but not enough for another ten years. So, is there a better method? For an easily-controlled airproof seal, spray or brush on PVA (poly vinyl acetate). This is a green liquid that dries over the repair and blocks air as the gelcoat cures. It then washes off with water. Should be available wherever you buy fiberglass supplies. Harold *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Tue Dec 16 2003 - 14:53:58 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:11 PDT