I temporarily removed the seat in a Falcon 16. I cut the pillars halfway and when I replaced the seat, I made sure it was attached to the hull using glue and foam. I used two sheets of ABS plastic to sandwich the cut and used SS pop rivets to secure it. I also glued foam between the pillars and hull for extra stability. *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Wed Mar 31 2004 - 05:50:33 PST
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:14 PDT