[Paddlewise] Electric Bilge Pump Question

Hello,

I am trying to finish my electric bilge pump for my kayak. At first, I was
thinking electronic valves, but I found that they will not do the job for
me. They are too big and expensive, among other things.

So, I am asking for your help - I need one of these two things (either, not
both):

1.) Either 3/4 inch, 1 inch, 1 1/8 inch (ideal) check valve. The check valve
must be small, semi cheap, seal perfectly when closed (not ONE drip), and be
able to open with the slightest pressure (just a dribble of water pushing up
from the pump)

[or]

2.) A 3/4 inch or 1 1/8 inch 12 volt electric water pump (about 800-1000
gallons per hour) that needs to be pretty light. The pump MUST not let ONE
drip of water back through it when off. This means it will act as a check
valve. I had bought one at West Marine, where they told me it didn't let any
water back, but it does. :-(

Thanks for your help!

Karl
***************************************************************************
PaddleWise Paddling Mailing List - Any opinions or suggestions expressed
here are solely those of the writer(s). You must assume the entire
responsibility for reliance upon them. All postings copyright the author.
Submissions:     PaddleWise_at_PaddleWise.net
Subscriptions:   PaddleWise-request_at_PaddleWise.net
Website:         http://www.paddlewise.net/
***************************************************************************