In a message dated 8/24/2004 6:37:52 PM Pacific Daylight Time, dalloyd_at_telus.net writes: > Making some European-bench style boat sawhorses this week out of 3X3 > laminated pine, two full crossmembers, two uprights, all bolted together > with 30" 3/8' threaded rod through the two vertical members on each stand. > Feet are 2X6X30 pine with Honduras mahogany feet with adjustable levellers. > Should be stable enough. Can't wait to see what boats get built on these > stands! > You're faster than I am. I did, however, hire the naval architect firm of Baker, Baker and Brewer, to help me splash a design of a few hundred years age. I would have taken the lines off a Max, but I think the designer would get mad, and anyway, I live far too close to get away with it. Rob G *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Tue Aug 24 2004 - 20:34:24 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:16 PDT