There are a few types that I see for sale on ebay almost everyday. But for a cheap alternative, I took some > inch aluminum conduit, and bent them in a J shape. Drilled two < mounting holes in the flat portion, and hung them on the wall. I then slipped pipe insulation over them to help protect the hull. It will take a minor amount of brain work to get the radius right, but that's the beauty of aluminum, it is easily adjusted for minor nuances. I have two stacked one atop the other, and I only lost about 18 inches of floor space to them. I have mine set so the hulls are facing the wall. Mitch Merritt Allied Wholesale Electrical Supply Inc. 120 N. Lynhurst Indianapolis, IN. 46224 Office 1-317-487-4100 Fax 1-317-487-4101 *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:33:40 PDT