Re: [Paddlewise] pump hangers, where to find then

If this is it (from the site below):

"Bilge Clip Kit
. Secures pump on deck where it is easy to reach . 1 5/8" diameter nylon 
clip . Works with our bilge pump or any similarly sized items . Installs with 
two 10 -32 - 5/8" screws . Not designed to secure pump when cartopping "

I would not recommend it.  That clip will break off the first time it takes a 
good hit.  I secured some strips of velcro using some adhesive to a couple 
PVC holdfasts (don't have a link) to the inside of the hull of my single, 
just behind my seat.  The velcro strips close __over__ the pump shaft, 
forming loops.  Never a failure in this in some 10 years of use, and easy to 
loosen with stiff fingers or neoprene gloves.

--
Dave Kruger
Astoria, OR
----- Original Message ----- 
From: "Chris Madden" <maddencg_at_earthlink.net>

Subject: Re: [Paddlewise] pump hangers, where to find then


> This might work.

> http://www.oakorchardcanoe.com/accessories.htm 
***************************************************************************
PaddleWise Paddling Mailing List - Any opinions or suggestions expressed
here are solely those of the writer(s). You must assume the entire
responsibility for reliance upon them. All postings copyright the author.
Submissions:     PaddleWise_at_PaddleWise.net
Subscriptions:   PaddleWise-request_at_PaddleWise.net
Website:         http://www.paddlewise.net/
***************************************************************************