On Tue, 3 Oct 2006 21:19:51 -0700 (PDT), Derek wrote: I tried using a "Sharpie" marker on the pump. This should be permanent, but it rubbed off pretty easily. I considered a scratch pen, but would prefer something more obvious. Try using the 'scratch pen' and then follow over it with the Sharpie. The ink will lodge in the scratch and be much more likely to remain. I have found that some of the electronic/tape labeler systems have a very agressive adhesive that seems pretty good. FWIW --allan *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Wed Oct 04 2006 - 06:16:20 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:21 PDT