On 23 May 2005 at 20:10, Dave Kruger wrote: > Tom, until we know something about the plastic, it is a little tough > to tell which adhesive will work, If it's the same as most Current Design's kayaks, it's ABS afaik. Black plastic, either smooth or pebbled surface? > although nine chances out of ten, if > you roughen the surfaces adjacent to the crack, out half an inch or > so, with 80-grit sandpaper, Aquaseal will take care of it. Or 3m 5200. Mike *************************************************************************** PaddleWise Paddling Mailing List - Any opinions or suggestions expressed here are solely those of the writer(s). You must assume the entire responsibility for reliance upon them. All postings copyright the author. Submissions: PaddleWise_at_PaddleWise.net Subscriptions: PaddleWise-request_at_PaddleWise.net Website: http://www.paddlewise.net/ ***************************************************************************Received on Mon May 23 2005 - 21:40:47 PDT
This archive was generated by hypermail 2.4.0 : Thu Aug 21 2025 - 16:31:21 PDT